usb: gadget: atmel_usba_udc: Expose correct device speed

commit d134c48d889ddceadf4c990e6f3df16b816ed5d4 upstream.

Following changes that appeared in lk 4.0.0, the gadget udc driver for
some ARM based Atmel SoCs (e.g. at91sam9x5 and sama5d3 families)
incorrectly deduced full-speed USB link speed even when the hardware
had negotiated a high-speed link. The fix is to make sure that the
UDPHS Interrupt Enable Register value does not mask the SPEED bit
in the Interrupt Status Register.

For a mass storage gadget this problem lead to failures when the host
had a USB 3 port with the xhci_hcd driver. If the host was a USB 2
port using the ehci_hcd driver then the mass storage gadget worked
(but probably at a lower speed than it should have).

Signed-off-by: Douglas Gilbert <dgilbert@interlog.com>
Reviewed-by: Boris Brezillon <boris.brezillon@free-electrons.com>
Fixes: 9870d895ad87 ("usb: atmel_usba_udc: Mask status with enabled irqs")
Signed-off-by: Felipe Balbi <balbi@ti.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

diff --git a/drivers/usb/gadget/udc/atmel_usba_udc.c b/drivers/usb/gadget/udc/atmel_usba_udc.c
index 4095cce05e6a729ccf86ff5f6394e55f7cf0511f..35fff450bdc8f48e27f1218a4d46bc4241b61f70 100644 (file)
--- a/drivers/usb/gadget/udc/atmel_usba_udc.c
+++ b/drivers/usb/gadget/udc/atmel_usba_udc.c
@@ -1634,7 +1634,7 @@ static irqreturn_t usba_udc_irq(int irq, void *devid)
        spin_lock(&udc->lock);
 
        int_enb = usba_int_enb_get(udc);
-       status = usba_readl(udc, INT_STA) & int_enb;
+       status = usba_readl(udc, INT_STA) & (int_enb | USBA_HIGH_SPEED);
        DBG(DBG_INT, "irq, status=%#08x\n", status);
 
        if (status & USBA_DET_SUSPEND) {